Wireless heat alarm GS412
Protect yourself and your family with the wireless heat detector GS412. By networking the heat detectors with each other or with the smoke alarm (SD_GS559A), you can hear an alarm even in distant rooms in the house or apartment. Wherever a networked heat detector or smoke detector is installed. All networked alarms trigger an alarm as soon as an alarm detects excessive heat or smoke. Up to 15 wireless alarm detectors of the same product line can be networked together.
This heat meter is used for early warning in case of hazardous heat development in rooms up to 40 m². As soon as an ambient temperature of more than 54 ° C is reached, the LED flashes and a loud alarm signal sounds. A self-test, performed every 32 seconds, indicates that you are still protected. This is noticeable by a short flashing of the LED light. You can also test yourself at any time using the test button. With the anti-disturb function, the early warning system can be muted for device replacement for 10 hours. The heat detector still retains its functionality.
Heat alarms are particularly suitable for kitchens or rooms, where is strongly smoked.
Please note that this heat meter can only be used in private rooms. It is used for early fire detection, not for fire prevention or extinguishing. It is also not a substitute for smoke, gas, or CO detectors.
Product features
- Model: GS412 (wireless heat detector)
- Networking: Up to 15 networking alarm detectors of the same manufacturer and product line
- Compatibility: networkable with GS559A, GS412, GS156A, GS816A, GS188
- Radio range max.: approx. 100m on open area, approx. 35m across closed rooms
- Room size: 20 - 40qm
- Dimensions: Ø99 x 28mm
- Heat sensitivity: 54 - 70°C
- Humidity: 10 - 95%.
- Alarm volume : ≥ 85dB(A) within 3 meters
- Low battery warning
- Mute 10 hours for device change
- Mute 10 minutes on false alarm
- Approvals: BS5446-2:2003
- Radio frequency: 868MHz
- Power supply: 2 x 1.5V DC batteries type AA
Installation and operating instructions as PDF
Magnetic fastening for heat detectors
With the magnetic fastenings for heat detectors, you can install your heat detectors quickly and easily. They save drilling and unsightly drill holes. Screws and dowels are not required with this fastening method. The magnetic attachment consists of two self-adhesive magnetic pads. These two self-adhesive magnetic pads, each on one side, have a highly self-adhesive material (3M adhesive). One magnetic pad is attached to the ceiling and the other is on the back of the heat detector - then the magnetic fixture is ready for your heat detector.
Note: For vinyl tapes, styrofoam, non-stick coated, siliconized or Teflon coated surfaces the magnetic fixture or magnetic holder is not suitable.
Installation instructions as PDF
Scope of delivery:
- 1 x Wireless heat alarm GS412
- 2 x 1.5V DC batteries
- 2 x Mountig screws
- 2 x Dowels
- 1 x Magnetic fastening
Plenty Lions
