Wireless smoke alarm an heat detector GS559A
Protect yourself and your family even better with the wireless smoke detector GS559A, which triggers an alarm in case of excessive smoke development and/or unusually high room temperature. Networked wireless smoke alarms offer even better protection, as you can no longer overhear a warning signal if it is triggered in a remote room. All networked smoke alarms trigger an alarm if smoke or excessive heat is detected.
The early warning system alerts you with a beep and LED signal every 50 seconds that the batteries need to be replaced. With the anti-disturb function, the early warning system can be muted for device replacement for 10 hours. The smoke detector still retains its functionality. The self-test, which is performed every 50 seconds, shows that you are protected. This is indicated by a short flashing of the LED light. You can also perform a test yourself at any time with the test button.
Up to 15 networking alarm detectors of the same product line can be networked together. The radio range is designed for apartments and single-family houses and is approx. 35m, depending on local conditions.
Product features
- Model: GS559A (wireless smoke and heat alarm)
- Networking: Up to 15 networking alarm detectors of the same manufacturer and product line
- Compatibility: networkable with GS559A, GS412, GS156A, GS816A, GS188
- Radio range: approx. 100m on open area, approx. 35m across closed rooms
- Dimensions: Ø120 x 34mm
- Heat sensitivity: 54 - 70°C
- Alarm volume : ≥ 85dB (A) within 3 meters
- Certifications: EN 14604
- Low battery warning
- Mute 10 hours for device change
- Mute 10 minutes on false alarm
- Radio frequency: 868MHz
- Power supply: 2 x 1.5V DC batteries type AA
Certificate of constancy of performance as PDF
Magnetic fastening for smoke detectors
With the magnetic fastenings for smoke detectors, you can install your smoke detectors quickly and easily. They save drilling and unsightly drill holes. Screws and dowels are not required with this fastening method. The magnetic attachment consists of two self-adhesive magnetic pads. These two self-adhesive magnetic pads, each on one side, have a highly self-adhesive material (3M adhesive). One magnetic pad is attached to the ceiling and the other is on the back of the smoke detector - then the magnetic fixture is ready for your smoke detector.
Note: For vinyl tapes, styrofoam, non-stick coated, siliconized or Teflon coated surfaces the magnetic fixture or magnetic holder is not suitable.
Installation instructions as PDF
Scope of delivery:
- 1 x Wireless smoke alarm GS559A
- 2 x 1,5V DC Type: AA batteries
- 2 x Mounting screws
- 2 x Dowels
- 1 x Magnetic fastening
Plenty Lions
